sndwvs |
05-08-2024 11:56 AM |
SpacemiT Banana Pi F3 K1 (riscv64)
2 Attachment(s)
information board:
https://banana-pi.org
Specifications
wiki
buy
support
image_build_kit irradium (based on crux linux), slarm64 (Slackware aarch64 / riscv64 unofficial port)
Specifications (information from cnx-software.com):
- SoC – SpacemiT K1
CPU – 8-core X60 RISC-V processor with single-core performance equivalent to about 1.3x the performance of an Arm Cortex-A55
GPU – Imagination IMG BXE-2-32 with support for OpenCL 3.0, OpenGL ES3.2, Vulkan 1.2
VPU – H.265, H.264, VP9, VP8 4K encoding/encoding
NPU – 2.0 TOPS AI accelerator
- System Memory – 2GB or 4GB LPDDR4 (Note: The K1 SoC supports up to 16GB)
- Storage
8GB or 16GB eMMC flash
MicroSD card slot
Optional 32M SPI NAND flash
Optional 4M SPI NOR flash
Optional SATA port (via M.2 module)
- Display Interfaces
HDMI 1.4 up to 1080p60
4-lane MIPI DSI connector
- Audio – Speaker header, onboard stereo microphone, 3.5mm headphone jack, digital audio via HDMI
- Camera – 2x 4-lane MIPI-CSI connectors
- Networking
2x Gigabit Ethernet RJ45 ports via Realtek RTL8211F transceivers; support for PoE via RT5400 expansion board
Dual-band 2.4GHz/5GHz WiFi 5 and Bluetooth 4.2 via Realtek RTL8852BS module
- USB
4x USB 3.0 Type-A ports via VL817 USB 3.0 hub (so bandwidth is shared, also see block diagram below)
1x USB 2.0 Type-C OTG port
- Expansion
M.2 Key-M socket (PCIe 2.1 x2); supports JMB582 SATA expansion card
mPCIe socket (PCIE 2.1 x1)
26-pin header GPIO header
- Debugging – 3-pin UART connector
- Misc
Reset, Power, and Burn buttons
IR receiver
Power LED
DIP switch for boot selection
Fan header
- Power Supply – 12V/3A via DC jack or USB Type-C port (strangely placed at opposite corners of the board)
- Dimensions – 148×100 mm
- Weight – 200 grams
|